[XPB-XL-X] Our commercial restroom Xlerator Hand Dryer dries hands completely in a fast 10 to 15 seconds. Also using 80% less energy. The dimensions are: 11 3/4" LG. X 12 11/16" HIGH X 6 11/16" DEEP. The construction of the Xlerator Hand Dryer's cover is a one-piece, heavy-duty, rib-reinforced, die-cast zinc alloy. It's lightweight, unbreakable, rustproof and all exposed surfaces shall be bright chrome plated or finished with chip-proof, electrostatically applied epoxy paint and fastened to a wall plate by two chrome plated tamper-proof bolts. Hand dryer wall plate is equipped with (3) 7/8" (22 mm) diameter holes, one of which shall be suitable for use with surface conduit, for ease of wiring. All internal hand dryer parts are coated. The warm air hand dryer heating element (900 W) is constructed of Nichrome wire and mounted inside the blower housing, thereby being vandal proof. It's protected by an automatic resetting thermostat, which shall open whenever air flow is cut off and shall close when flow of air is resumed. It also produces an air temperature of up to 135°F (57°C) at a 72°F (22°C) ambient room temperature at the hands (4 inches [102 mm] below air outlet). The Xlerator Hand Dryer Control assembly is activated by an infrared optical sensor located next to the air outlet. The dryer shall operate as long as hands are under the air outlet. There is a 35-second lockout feature if hands are not removed. For shipping quote prices, orders or questions please call our Customer Service Center at 1-877-483-9270.